Pre-Assembly Instructions - Grand Cafe CSM07ALP Operator's Manual

Pre-Assembly Instructions For Your Safety
WARNING
!
Failure to comply with these instructions could
result in a fire or explosion that could cause
serious bodily injury, death or property damage.
Spiders and small insects can spin webs and
nest in the smoker Burner Tubes during transit
and warehousing which can lead to a gas flow
obstruction resulting in a fire in and around the
Burner Tubes. This type of "FLASHBACK FIRE"
can cause serious smoker damage and create
an unsafe operating condition for the user.
To reduce the chance of FLASHBACK
FIRE you must clean the Burner Tubes
as follows before initial use.
least once a month in summer and fall or
whenever spiders are active in your area, and if
your smoker has not been used for an extended
period of time.
.
1
Remove the screw from the rear of Burner using
a Phillips Head Screwdriver.
.
2 Carefully lift Burner up and away from the Gas
Valve Orifice.
.
3 Check and clean Burner/Venturi Tubes for insects
and insect nests. A clogged tube can lead to a fire
beneath the smoker.
.
4 Refer to the figure below and perform one of
these 3 cleaning methods:
METHOD 1: Bend a stiff wire or wire coat
hanger into a small hook as shown and run
the hook through the Burner Tube and inside
the Burner several times to remove debris.
TO CLEAN BURNER TUBE, INSERT HOOK
HERE
9
METHOD 2: Use a bottle brush with a flexible
handle and run the brush through the Burner
Tube and inside the Burner several times to
remove any debris.
METHOD 3: Use an air hose to force air
through Burner Tube. The forced air should
pass debris or obstructions through the
Burner and out the Ports.
For safe operation ensure the Gas Valve Assem-
bly Orifice is inside the Burner Tube before using
your smoker. See figure. If the Orifice is not
inside the Burner Tube, lighting the Burner may
cause explosion and/or fire resulting in serious
bodily injury and/or property damage.
Gas Valve
Assembly
Also do this at
Burner Tube
Burner Tube
Orifice
To expedite the assembly process follow these
!
general guidelines:
Tools Required for Assembly
•
protective work gloves
•
protective eyewear
•
Phillips Head Screwdriver
•
wrench (included)
While it is possible for one person to unpack this gas
smoker, obtain assistance from another person when
handling the large pieces.
Use the Hardware and Part Diagram to ensure all
items are included and free of damage.
Do not assemble or operate the smoker if it appears
damaged. If there are damaged or missing parts
when you unpack the shipping box or you have
questions during the assembly process, call the:
Customer Support Helpline 1-800-761-5456
8am-4:30pm CST, Monday through Friday
Installation Codes
The installation must conform with local codes or, in
the absence of local codes, with either the National
Fuel Gas Code, ANSI Z223.1/NFPA 54, Natural Gas
and Propane Installation Code, CSA B149.1, or
Propane Storage and Handling Code, B149.2.
3
include: