Switching On/Off - Standby Button; Channel Preset - Palsonic 4910 Owner's Manual

3.1 STANDBY ( ) Button
3.1.1 Press STANDBY (
is in STANDBY mode (the indicator shows red) , the channel position number is displayed
in the screen. Press STANDBY (
the set is in OPERATION mode, and the indicator shows red.

3.2 CHANNEL PRESET

3.2.1 AUTO PRESET
3.2.1.1 Press PRESET ON/OFF button to set PRESET mode. The current band and channel
position will be displayed on screen. (In green)
3.2.1.2 Press AUTO PRESET button, the appliance will search for the signal of TV stations
in the order of VHFL, VHFH and UHF as shown in the following and memorise them
from channel number 1 position.
VHFL
3.2.1.3 When presetting is over, the channel position is set to number 1 automatically.
3.2.1.4 Press PRESET ON/OFF button to exit preset mode.
NOTE: * During presetting, the green bar turns into yellow.
The moving bar indicates the change of tuning frequencies.
* During presetting, auto presetting will be cut off if any one of STAND BY button,
PRESET ON/OFF button or AUTO PRESET button is pressed.
3.2.2 MANUAL TUNING
3.2.2.1 Press PRESET ON/OFF button to set preset mode.
3.2.2.2 Select a channel position.
If "SKIP" displays on the screen, press "SKIP" button to exit "SKIP" mode.
8 SKIP
llllllllll.....
3.2.2.3 Press and hold MANUAL TUNING button until your desired program appears.
MFT
) button to turn on the set (the indicator shows yellow) when the set
) button to return the set to the STANDBY mode when
VHFH
SKIP
VHFL
VHFL
UHF
8 VHFH
lllllllll.....
UHF
VHFH
VHFH
UHF
3