Table of Contents
Advertisement
Anti-tips, turnable
The anti-tips
are mounted
on the tilters.
5 mm
After adjusting the
seat height or centre
of balance, always
ensure that you check
the function of the
anti-tips.
Adjustable upholstery (option)
The contour of the backrest upholstery is
individually adjustable by using the five Velcro
straps and the backrest cover.
– Allow the cover plenty of room between
seat and backrest, so that it is possible to
"sit in" against the backrest.
– Loosen all the straps and ensure that the
user is sitting as far back in the seat as
possible.
– Tighten the straps so that they follow the
contours of the back and give support for
the curve of the back.
Push handles, vertically adjustable (option)
Only in combination with vertically adjustable
push handle attachments.
The push handles can be set at intervals
of 2 cm.
Loosen the knob (A) and press the plastic
washer inwards. Install desired height. Ensure
that the push handles are locked in the correct
position. Tighten the knob.
4. Readjustments
1
2
Risk of tipping: Always check the posi-
tioning of the anti-tips after adjusting
the backrest upholstery.
(!) Do not over-
tighten the upper
straps as this
can prevent the
cross-brace from
unfolding properly,
i.e. the back tubes
do not sit flush in
the side-frames.
Ensure that the
knob is properly
tightened. This is
especially important
if the chair is to be
lifted with the user
sitting in it.
20
3
4 - 6.5 cm
Advertisement
Table of Contents
