Adjusting Hand And Day Indicator Alignment; Moving To Another Time Zone - Casio WTP-150 Operation Manual

Adjusting Hand and
Day Indicator
Alignment
Strong magnetism or impact can cause the
time indicated by the hands and the day
indicator to go out of alignment. If this
happens, adjust hand and day indicator
alignment.
The watch performs alignment of the hour
●
hand, minute hand, and second hand
automatically.
Adjusting Hand and Day
Indicator Alignment
1.
Pull out the crown to the second click.
2.
Hold down (B) for about five seconds, until
the second hand moves to 12 o'clock.
This starts auto alignment of the hour
hand, minute hand, and second hand.
After auto alignment is complete, the
●
hands should be in the positions shown
below.
Minute hand
Second
hand
Hour hand
3.
Press (C).
Confirm that the small hour hand and
small minute hand, and the small 24-hour
hand are stopped at 12 o'clock.
Small hour hand
Small minute hand
Small 24-hour hand
4.
If the small hour hand and small minute
hand, and the small 24-hour hand are not
at 12 o'clock, rotate the crown to align
them correctly.
Operation Guide 5453
5.
Press (C).
Confirm that the mode hand is stopped at
12 o'clock, and check if the day is
indicated properly.
Mode hand
Day (Operation start day)
6.
If the mode hand or the day indicator is not
in the proper position, rotate the crown to
move the mode hand to 12 o'clock and the
day to the center of the indicator window.
The movement range of the mode hand
●
and day indicator is limited when you
rotate the crown. The maximum left-
right movement of the mode hand is 180
degrees in either direction. The day
indicator moves only slightly.
After the mode hand and day indicator
●
are in the positions you want, advance
to step 9 of this procedure. If you are
unable to make the adjustments you
want, go to step 7.
7.
Press (C).
Confirm that the day indicator shows 1.
Crown
Changing the date setting will cause the
●
mode hand to rotate repeatedly. In
some cases, the mode hand may
continue to rotate for about 30 minutes.
Changing Hand and the Day
l
Indicator Settings
8.
If 1 is not shown for the day, rotate the
crown until 1 is shown.
The mode hand moves in conjunction
●
with crown rotation. Move the mode
hand to 12 o'clock.
9.
Push the crown back in.
Moving to Another Time
Use the procedure below to easily change day
and time settings of the watch to a destination
location.
●
Select a World Time City that corresponds to
your destination.
Day
l
●
Swap the origin time zone time with the
destination time zone time.
l
Note
Leaving the crown pulled out for
●
more than approximately 30 minutes
without performing any operation
will automatically cause the
adjustment operation to become
disabled. If this happens, push the
crown back in to its normal position
and then pull it out again to restart
the procedure from the beginning.
Pushing the crown in to its normal
position part way through the
alignment procedure will cause the
hands to return to their normal
position. Any alignment you
performed up to that point will be
applied.
Zone
Before Boarding
Current time
Destination time
Specifying a World Time City
After Arriving
Before swapping After swapping
n
Destination time Destination time
Swapping the World Time and Current
Location Time
9