Dell powervault md3000i Installation And Troubleshooting Manual page 46

Router IP address:
XXXX:XXXX:XXXX:XXXX:XXXX:XXXX:XXXX:XXXX
Where 'X' is a hexadecimal number between 0 and F.
The following settings are available (depending on your specific
configuration) by clicking the Advanced button:
• Virtual LAN (VLAN) support
A VLAN is a network of different systems that behave as if they are
connected to the same segments of a local area network (LAN) and are
supported by the same switches and routers. When configured as a
VLAN, a device can be moved to another location without being
reconfigured. To use VLAN on your storage array, obtain the VLAN ID
from your network administrator and enter it here.
• Ethernet priority
This parameter is set to determine a network access priority.
• TCP listening port
The port number used by the controller on the storage array to listen
for iSCSI logins from host server iSCSI initiators.
NOTE:
storage array controller uses to connect to an iSNS system. This allows the
iSNS system to register the iSCSI target and portals of the storage array so
that the host server initiators can identify them.
• Jumbo frames
Jumbo Ethernet frames are created when the maximum transmission
units (MTUs) are larger than 1500 bytes per frame. This setting is
adjustable port-by-port.
3 To enable ICMP PING responses for all ports, select Enable ICMP PING
responses.
4 Click OK when all iSCSI storage array port configurations are complete.
5 Test the connection by performing a ping command on each iSCSI storage
array port.
46
Preparing Your Systems for Clustering
The TCP listening port for the iSNS system is the port number the