Chevrolet CAMARO 2015 Owner's Manual page 25

Hide thumbs Also See for CAMARO 2015:
Table of Contents

Advertisement

2-4
Keys, Doors, and Windows
(Unlock): Press to unlock the
driver door or all doors. See Vehicle
Personalisation on page 5-36.
Pressing
will disarm the alarm
system. See Vehicle Alarm System
on page 2-11.
(Remote Boot Release):
Press and hold to release the boot.
(Vehicle Locator/Panic
Alarm): Press and release one
time to initiate vehicle locator. The
exterior lamps flash and the horn
chirps three times.
Press and hold
for at least
three seconds to sound the panic
alarm. The horn sounds and the
indicators flash until
again or the key is placed in the
ignition and turned to ON/RUN.
(Remote Vehicle Start):
If equipped, press
and then
start the engine from outside the
vehicle using the RKE transmitter.
See Remote Vehicle Start on
page 2-5 for additional information.
The transmitter buttons will not
operate when the key is in the
ignition.
Programming Transmitters to
the Vehicle
Only RKE transmitters programmed
to this vehicle will work. If a
transmitter is lost or stolen, a
replacement can be purchased and
programmed through your dealer.
When the replacement transmitter is
programmed to this vehicle, all
remaining transmitters must also be
reprogrammed. Any lost or stolen
transmitters will no longer work
once the new transmitter is
programmed.
is pressed
Battery Replacement
Make sure that you dispose of old
to
batteries in accordance with
environmental protection
regulations to help protect the
environment and your health.
Warning
Caution
When replacing the battery, do
not touch any of the circuitry on
the transmitter. Static from your
body could damage the
transmitter.
The battery is not rechargeable. To
replace the battery:
1. Open the battery cover on the
back of the transmitter by prying
with a finger.
2. Remove the used battery by
pushing on battery and sliding
toward the key blade.
3. Insert the new battery, positive
side facing up. Push the battery
down to until it is held in place.
Replace with a CR2032 or
equivalent battery.
4. Snap the battery cover back on
to the transmitter.

Advertisement

Table of Contents
loading

Table of Contents