Table of Contents
Advertisement
10-50
Vehicle Care
Use this rotation pattern when
rotating tyres of the same size
installed on all four wheel
positions.
If the vehicle has a compact
spare tyre, do not include it in
the tyre rotation.
Adjust the front and rear tyres to
the recommended inflation
pressure on the Tyre and
Loading Information label after
the tyres have been rotated. See
Tyre Pressure on page 10-42
and Vehicle Load Limits on
page 9-10.
Reset the Tyre Pressure Monitor
System. See Tyre Pressure
Monitor Operation on
page 10-45.
Check that all wheel nuts are
properly tightened. See Wheel
Nut Torque under Capacities
and Specifications on
page 12-3.
Warning
Rust or dirt on a wheel, or on the
parts to which it is fastened, can
make wheel nuts become loose
after time. The wheel could come
off and cause an accident. When
changing a wheel, remove any
rust or dirt from places where the
wheel attaches to the vehicle. In
an emergency, a cloth or a paper
towel can be used; however, use
a scraper or wire brush later to
remove all rust or dirt.
Lightly coat the centre of the
wheel hub with wheel bearing
grease after a wheel change or
tyre rotation to prevent corrosion
or rust build-up. Do not get
grease on the flat wheel
mounting surface or on the
wheel nuts or bolts.
Advertisement
Chapters
Table of Contents
