TP-Link ARCHER C7 Quick Installation Manual page 4

English
3. Power on the modem, wait
for 2 minutes and then power
on the router.
4. Check the following LEDs
t o e n s u r e t h e h a r d w a r e
connection is correct.
Note: If your Internet comes via an Ethernet cable from the wall instead of any DSL/Cable/Satellite modems, please connect
the Ethernet cable directly to the router's Internet port.
Configure the Router
01/
Connect your computer to the router (Wired or Wireless).
2
Power System
On Flashing
Note: If the 2.4G and 5G LEDs are not flashing, please verify that the
wireless switch on the rear panel of the router is on.
Method 1 Via Web Browser
Power On
INTERNET
Power On
2.4G 5G
Flashing Flashing
Internet
On/Flashing