Maintenance; Inspection And Maintenance - Husqvarna 536LiP4 Operator's Manual

Inspection and maintenance

Li-ion Li-ion
WARNING! Always remove the battery
!
before any maintenance on the machine.
IMPORTANT! Never clean the battery or the battery
charger with water. Strong cleaning agents can damage
the plastic.
All servicing and repair work on the machine requires
special training. This is especially true of the machine's
safety equipment. If your machine fails any of the checks
described below you must contact your service agent.
When you buy any of our products we guarantee the
availability of professional repairs and service. If the
retailer who sells your machine is not a servicing dealer,
ask him for the address of your nearest service agent.
Only use original spare parts.
Regularly check that the battery charger and the battery
are intact.
Changing chain drive gear
If you are the least unsure of how to change the drive
gear, you must first contact your retailer for help.
• Dismantle the nut for the chip guard and remove the
guard.

MAINTENANCE

• Dismantle the clip holding the washer and the chain
drive gear.
• Remove the washer.
• Remove the chain drive gear and replace it with a new
one.
Cleaning
• Clean the machine after use.
• Clean the oil tank vent with a brush.
• Clean under the chip guard with a brush.
• If the battery connector on the machine is dirty, clean
it by blowing them with compressed air or use a soft
brush.
• Make sure the battery and battery charger are clean
and that the terminals on the battery and the battery
charger are always clean and dry before the battery is
placed in the battery charger.
• Keep the battery guide tracks clean.
• Clean plastic parts with a clean and dry cloth.
–
English 25