Handle Removal - Whirlpool WRI51ABTWW Use Instructions

Leveling and door closing
Your refrigerator has two adjustable front feet — one on the
right and one on the left. In most cases, the refrigerator
should be steady when both feet are touching the floor.
If your refrigerator seems unsteady or if you want the doors
to close more easily, adjust the refrigerator's tilt using the
instructions below:
1. Move the refrigerator into its final location. If necessary,
open both doors to 90°.
2. The two leveling feet are located on the brackets on each
side of the product.
NOTE: Having someone push against the top of the
refrigerator takes some weight off the leveling feet.
This makes it easier to make adjustments.
3. Turn the leveling foot to the left to raise that side of the
product, or turn it to the right to lower that side of the
product.
NOTE: Both leveling feet should be snug against the floor,
and the rollers should not touch the floor. This keeps the
refrigerator from rolling forward when opening the doors.
4. Open both doors again and check that they close as easily
as you like. If not, tilt the refrigerator slightly more to the
rear by turning the leveling feet to the left.
It may take several more turns, and you should turn both
leveling feet the same amount.
5. Use a bubble level to check the leveling of the refrigerator.
NOTE: Whenever you need to move the refrigerator, turn
the leveling feet to the right until they are no longer
touching the ground. This will allow the refrigerator to roll
more easily.
Door alignment
The doors are designed to be slightly different heights when the
refrigerator is empty, in order to account for the weight of food
that will be placed on the doors. If the doors are still not aligned
after checking the leveling and loading the refrigerator with food,
follow the steps below to adjust the door alignment.
1. Loose the locking nut: with a wrench, rotate 2 turns
counterclockwise the locking nut.
2. Adjust as required: open the door and rotate the adjusting nut
counterclockwise to lift up the door and rotate the adjusting
nut clockwise to lower the door.
Maximum adjustment is 5 mm.
3. Tight back the locking nut: once the door's height is adjusted
as required, tight back the locking nut by rotating it clockwise
with a wrench.
Bottom hinge
Levelling feet

Handle removal

To remove the handles:
1. Remove the handles, using hexagon spanner tool according
shown picture.
NOTE: To avoid scratching the finish, place the handles on a
towel or other soft surface.
The handle can be removed by hexagon spanner
directly.
8
No leveled
Adjusting nut
Locking nut
Wrench