Ice Maker And Storage Bin; Smart Ice; Water Filtration System - Whirlpool WRI51ABTWW Use Instructions

Ice maker and storage bin

■ Allow 24 hours to produce the first batch of ice. Discard the
first three batches of ice produced.
■ The quality of your ice will be only as good as the quality of
the water supplied to your ice maker. Avoid connecting the
ice maker to a softened water supply. Water softener
chemicals (such as salt) can damage parts of the ice maker
and lead to poor quality ice. If a softened water supply
cannot be avoided, make sure the water softener is operating
properly and is well maintained.
■
Do not use anything sharp to break up the ice in the storage
bin. This can cause damage to the ice container and the
dispenser mechanism.
■ Do not store anything on top of or in the ice maker or storage
bin.
Turning the ice maker On/Off:
■ Turn on or off the ice maker by pressing the "ice maker on/
off" button - the "ice maker disabled" light on indicates that
this feature is disabled
NOTE: The ice maker has an automatic shutoff to keep the
storage bin from overfilling during normal operation.
When the storage bin is at full capacity, the ice maker will
automatically stop ice production, but the ice maker fuction
will remain enable.

Smart Ice

Using the top funnel (1), fill the empty ice tray with potable water
– over fill way cause ice jam at drawer.
Press the button (2). To release the ice cubes from the ice tray to
the drawer.
Pull out the drawer to remove the ice cubes (3). To reduce ice
cubes freeze timing use cold water.
1
.
2
3
Water fi ltration system
Do not use with water that is microbiologically unsafe or of
unknown quality without adequate disinfection before or
after the system. Systems certified for cyst reduction may be
used on disinfected waters that may contain filterable cysts.
■ The product is for cold water use only.
■ The water system must be installed in compliance with state
and local laws and regulations.
Application guidelines / Water supply parameters
Water supply
Water pressure
Water temperature
Service flow rate
Water filter status light
The water filter status light will help you know when to change
your water filter.
■ When the dispenser control panel's water filter turns on ,
this tells you that it is almost time to change the water filter
cartridge .
Replacing the water filter
1. Close the water source.
2. Locate the water filter in the
internal top-right corner of
the refrigerator compartment.
3. Remove the filter, by
turning it clockwise.
NOTE: There may be
some water in the filter.
Some spilling may occur.
Use a towel to wipe up any spills.
4. Remove the packaging of the new filter and make
sure the o-rings ane properly positioned.
5. Insert the new filter into the lousing and lock it by turning it
cowterclockwise.
6. Open the water source and flush the water system
(see "Water and Ice dispensed" section.)
Resetting the filter status
■ After changing the water filter, reset the water filter pressing
and holding the FILTER RESET button for 3 seconds.
When the system is reset, the icons will turn off from the
display screen.
15
Potable city or well
21 - 120 psi (147 - 834 kPa)
33 °F - 100 °F (0,6 °C - 37,8 °C)
0,5 gpm (1,9 Lpm) @ 60 lb/pulg²
1
2
1
2