Table of Contents
Advertisement
WARNING!
Refer to Safety chapters.
What to do if...
PROBLEM
The appliance is noisy.
The lamp does not work.
The lamp does not work.
The compressor operates
continually.
The compressor does not
start immediately after
pressing the QuickFreeze,
or after changing the tem-
perature.
Water flows inside the re-
frigerator.
Water flows on the floor.
POSSIBLE CAUSE
The appliance is not sup-
ported properly.
The lamp is in stand-by.
The lamp is defective.
Temperature is set incor-
rectly.
Many food products were
put in at the same time.
The room temperature is
too high.
Food products placed in the
appliance were too warm.
The QuickFreeze function is
switched on.
This is normal, no error has
occurred.
The water outlet is clogged. Clean the water outlet.
Food products prevent that
water flows into the water
collector.
The melting water outlet is
not connected to the evap-
orative tray above the com-
pressor.
TROUBLESHOOTING
SOLUTION
Check if the appliance stands
stable.
Close and open the door.
Contact the nearest Author-
ised Service Centre.
Refer to "Operation" chapter.
Wait some hours and then
check the temperature again.
Refer to climate class chart on
the rating plate.
Allow food products to cool to
room temperature before stor-
ing.
Refer to "QuickFreeze func-
tion".
The compressor starts after a
period of time.
Make sure that food products
do not touch the rear plate.
Attach the melting water out-
let to the evaporative tray.
9
Advertisement
Table of Contents
