Mounting The Camera - D-Link DCS-820L User Manual

Section 2: Installation
WARNING - STRANGULATION HAZARD
Children have STRANGLED in cords. Keep adapter cord out of reach of children (minimum of three feet away). NEVER place the camera or adapter cord inside
the crib or child's sleeping area. Do not use extension cords. This product is NOT intended to replace proper adult supervision of children.
Refer to the steps below for mounting the camera. The DCS-820L is for indoor use only. We suggest you configure the camera before mounting it.
1. Use a 6mm drill bit to drill two holes that are 43mm apart, and at least 30mm deep.
2. Use a mallet to insert the wall anchors into the holes. Screw the included screws into the
wall anchors.
3. Place the mounting holes on the base of the camera over the screws as shown, then slide
the camera down to mount the camera.
4. Make sure the camera is positioned so that the D-Link logo is at the bottom of the base.
Adjust the angle of the camera as desired.
D-Link DCS-820L User Manual

Mounting the Camera

1
30mm
43mm
2
3
DCS-820L
IC: 4216A-CS825LA1 FCC ID: KA2CS825LA1
CAN ICES-3 (B)/NMB-3(B)
Model: DCS-820LA1
4
30mm
43mm
14