Installing The Back I/O Caps; Installing The Back I/O Dust Filter - Asus SABERTOOTH Z170 MARK 1 Accessory Installation Manual

Installing the back I/O caps

The SABERTOOTH Z170 MARK 1 accessory package takes protection to the next level with the
back I/O port caps.
Refer to the illustrated guide for the proper placement of back I/O caps:
To support various models, your package may include additional back I/O port caps for your
motherboard.

Installing the back I/O dust filter

The back I/O dust filter helps reduce the intake of dust and small particles into the system
To install the back I/O dust filter:
1. Match and align four (4) holes of the back I/O
dust grid and four (4) fasteners of the back I/O
dust frame then attach the dust grid to the dust
frame.
2. Match and align the four (4) fasteners of the
back I/O dust frame and grid assembly to the
four (4) circular holes on the back I/O fan vent
of the I/O shield then push to fasten the back
I/O dust grid into the I/O shield with the back
I/O dust frame.
Clean your back I/O dust filter from time to time, especially when it is dirty, to ensure optimum
airflow.
8
Back I/O dust frame
Back I/O dust grid
I/O shield