Asus SABERTOOTH Z170 MARK 1 Accessory Installation Manual page 6

To install the 35 mm assistant fan on the cover hatch:
1. Locate and remove the screws from the cover
hatch (A) then remove the lid from the Thermal
Armor cover (B).
You can attach the bead chain to the Thermal
Armor cover.
2. Get the 35 mm assistant fan and position it to
an orientation where its THE ULTIMATE FORCE
logo is facing up.
3. Match the four (4) screw holes on the assistant
fan with the four (4) screw holes on the cover
hatch and secure it with the bundled set of four
(4) long screws for the 35 mm assistant fan.
The screwdriver is not included in the accessory
package.
4. Connect the fan cable connector to the assistant
fan (ASST_FAN2) header on the motherboard.
6