LG LWS3081ST Installation Manual page 6

Part 2 INSTALLATION REQUIREMENTS
The first step of the installation is measure the current cutout dimensions and compare them to the cutout
IMPORTANT NOTE
braces or runners must be installed level with the bottom of the cutout to support the weight of the oven.
will tend to slide out when opening the door.
shims under the runners and front trim until the marks or opening are covered.
to establish the cutout width.
Dimensions are the same as the single built-in oven on page 4.
Gas or electric cooktops may be installed over this oven.
See cooktop installation instructions for cutout size.
See label on top of oven for approved cooktop models.
25" (63.5 cm)
Top and/or side fillers
may be necessary if
unit is positioned
between existing
cabinets. Be sure they
are attached securely
since, they will anchor
the oven in the cabinets.
240 V / 208 V
Junction Box Location
(Junction box may be
in adjacent cabinet)
Allow 1" (2.5 cm)
28 15/16" (73.5 cm) Min.
overlap top of oven,
29" (73.7 cm) Max.
1 1/16" (1.8 cm) overlap
side edges of cutout
and 1 1/4" (3.2 cm)
overlap bottom of oven.
28 1/2" (72.4 cm) Min.
28 5/8" (72.7 cm) Max.
- 6 -
Gas and electrical connections for
30" (76.2 cm) gas cooktop must be located
in an adjacent accessible location to the
right. For a 36" (91.4 cm) gas cooktop, the
connections may be made to the left.
5"
23 1/2" (59.7 cm) Min.
36" (91.4 cm)
Above Support
Typical
Platform
Countertop
Height
24" (61 cm)
2 3/4"(7 cm) ~ 4"(10.2 cm)