LG LWS3081ST Installation Manual page 5

Part 2 INSTALLATION REQUIREMENTS
2
The first step of the installation is measure the current cutout dimensions and compare them to the cutout
IMPORTANT NOTE
two braces or runners must be installed level with the bottom of the cutout to support the weight of the oven.
will tend to slide out when opening the door.
If marks, blemishes or the cutout opening are visible above the installed oven, it may be necessary to add wood
shims under the runners and front trim until the marks or opening are covered.
to establish the cutout width.
The junction box must be flush with the rear wall of the cabinet as shown below.
Allow at least a 23" clearance for the door depth when it is open.
27 3/8"
(69.5 cm)
Recommended
52 1/16"
(132.2 cm)
29 3/4"
(75.5 cm)
Allow 1"
minimum for
overlap of oven
23"
- 5 -
51 5/8"
(131.0 cm)
23 3/8"
(59.3 cm)
30"
5"
28 1/2" Min.
28 5/8" Max.
Allow 1"
51 13/16" Min.
minimum for
51 15/16" Max.
overlap of oven
23 1/2"
Minimum cutout location from floor 12"
Junction Box
Location
47"