Configuring The Connection For Fiery Utilities - Xerox Phaser EX7750 Ser3Oftware )Nstallation'uide

1
1-24 Installing User Software on a Windows Computer
Configuring the connection for Fiery utilities
The first time you start one of the Fiery utilities, you must configure the connection to
the EX7750. Similar configuration is used for all Fiery utilities, so any change in one
configuration affects all the other connections. Configuration for most Fiery utilities is
described in the following procedure.
For configuration of specific Fiery utilities, see the following:
• "Configuring the connection for EFI Fiery Mail Port"
• "Configuring the connection for Command WorkStation"
B
EFORE YOU BEGIN
• Print the Configuration page from the EX7750 Control Panel and note the IP address of
the EX7750.
• Print the Configuration page from the FACI and note the IP address of the EX7750.
This page contains information you need when configuring the connection, such as
the IP address. For TCP/IP installations, you can use the DNS name of the EX7750
instead of the IP address. Make sure the EX7750 is already registered in a Domain
Name Server (DNS) on your network. For more information, see your Windows
system documentation.
on page 1-27
on page 1-30