Xerox Phaser EX7750 Ser3Oftware )Nstallation'uide page 31

1
1-15 Setting up PostScript or PCL printing with Windows 2000/XP
9. Click the General tab and click Print Test Page.
10. In the printer Job Notes field, type user and job identification information and
click OK.
The Test Page remains listed in the queue window until it is printed.
The EX7750 polls the NetWare server for print jobs in the print connection defined
for the EX7750. When you print, your PostScript files are spooled to that connection
and transmitted over the queue "port" to the EX7750.
Setting up SMB printing on Windows 2000/XP
SMB printing (also known as Windows printing) allows you to install the printer
driver and associated files, and print from your computer to a particular print
connection (Hold, Print, or Direct) on the EX7750. These instructions assume you
have installed the TCP/IP protocol and Client for Microsoft Networks.
Each connection (Hold, Print, or Direct) requires a new printer driver and printer
description file. To set up printing to a second or third print connection, repeat the
procedure, "Setting up SMB printing on Windows
one printer, give each a descriptive name during printer driver installation, such as
or
Aero-Print
B
EFORE YOU BEGIN
• To check the setting for Enable SMB Print Services, print a Configuration page.
The default setting for Enable SMB Print Services on the EX7750 is Yes.
N :
OTE
• To change the setting, right-click the FieryBar on the FACI and choose Setup Fiery to
configure the EX7750. Then select Network Setup > Services > Windows Print Sharing
(SMB) > Enable SMB Print Services.
• At the Control Panel, configure the EX7750 for SMB printing in Run Setup > Network
Setup > Service Setup >Windows Setup.
SMB printing is referred to as Windows Printing in Setup, on the Control Panel Map,
and on the Configuration page. For more information, see the
, so you can easily identify printers.
Aero-Hold
2000/XP". If you install more than
Configuration Guide.