Omnitronic TM-2000 User Manual page 11

Caution!
Danger of explosion when battery is replaced improperly.
Only replace by the same type or similar types recommended by the manufacturer.
Remove empty battery in accordance with the instructions of the manufacturer.
Insert the 2 mignon-batteries (type AA) and make sure that the poles are correct.
In order to have a long battery life, you should only use alcaline batteries.
BATTERY DISPOSAL NOTICE
Please dispose of old and used batteries properly.
Batteries are hazardous waste and should not be disposed of with regular domestic waste!
Please take old and used batteries to a collection center near you.
5.2 Start-up
Screw the microphone lead into the microphone input socket.
Attach the pocket transmitter via the belt clip to the belt or waistband.
With the operation selector, you can switch the device on and off. When switching the device on, the LED
shortly lights up. In this case, the power supply is sufficient.
When the battery is getting weaker, the LED is permanently illuminated. In this case, the batteries have to be
replaced.
If the LED does not light up when switching on, there is either no battery inserted or the poles are wrong.
Frequency adjustment
- Hold the SET button for 3 seconds to activate the frequency menu.
- Once you see „MHz" blinking, you are ready to select your desired frequency by using the UP and DOWN
- buttons.
- Press SET to store your changes.
Sensitivity adjustment
- Hold the SET button for 3 seconds and activate the sensitivity menu.
- Once you see „DB" blinking, you can adjust the volume by using the UP and DOWN buttons.
11/23 00024304.DOC, Version 1.2