Media Bay - Dell Latitude D520 Service Manual

Back to Contents Page
Media Bay
Dell™ Latitude™ D520 Service Manual
NOTE: If the device security screw is not present, you can remove and install devices while the computer is running and connected to a docking device
(docked).
1. Save and close any open files, exit any open programs, and shut down the computer.
2. If the computer is connected to a docking device (docked), undock it. See the documentation that came with your docking device for instructions.
3. Close the display and turn the computer upside-down.
4. If present, remove the M2 x 3-mm device security screw from the bottom of the computer.
1 M2 x 3-mm security screw
5. Press in the device latch release, and pull the drive out of the media bay.
To replace the drive into the media bay, push the new device into the bay until it clicks, then replace the M2 x 3-mm security screw (if present).
Back to Contents Page
2 device latch release