Evinrude E15D Operator's Manual page 29

ON position.) Crank the engine no longer than
20 seconds.
1. Start button
Upon start-up, release the button.
If the engine did not start, release the button
momentarily, then try again.
NOTICE
The starter motor can be dam-
aged if operated continuously for more
than 20 seconds.
IMPORTANT: Engine will not start if outboard
is in gear or if tether cord is not in place.
If your outboard does not react normally to
this starting procedure or if it fails to start, re-
fer to Troubleshooting on page 62.
After Engine Starts
Check the water pump indicator. A steady
stream of water indicates the water pump is
working. If a steady stream of water from the
water pump indicator is not visible, stop the
engine. Refer to Engine Overheating on
page 43.
1. Water pump indicator
Engine Stopping
Twist the throttle grip to SLOWEST speed po-
sition.
Move shift lever to NEUTRAL.
Press the engine cut–off switch until the out-
board stops running. If equipped, close the
vent screw on the fuel tank's filler cap.
1
007010
Disconnecting the Fuel Hose
Disconnect the fuel hose from the fuel con-
nector.
1
If equipped, close vent screw on fuel tank cap.
007011
1. STOP button
A WARNING
A small amount of fuel may be released
when the fuel connector is disconnected.
Always wipe off any fuel spillage.
1. Fuel connector
O

PERATION
1
007012 HK
1
007004
27