Black & Decker 1766 Instruction Manual page 6

154408 manual 4/30/02 10:16 AM Page 3
Switch
FIGURE 1A - 1766 FIGURE 1B - 1788
The switch is located on the front of the grinder near the bottom. To turn the
tool on, depress the rocker switch near the word "ON". To turn the tool off,
depress the rocker switch near the word "OFF".
Installing Tool Rests
SMALL SMALL
BOLTS BOLTS
TURN OFF TOOL AND DISCONNECT FROM POWER SUPPLY.
Remove the tool rests from the top portion of the poly-foam carton liner and
install them to the wheel guards as shown in Figures 1A (1766) and 1B
(1788). Use the bolts and washers from the plastic bag to secure them in
place.
WASHERS WASHERS
RIGHT
RIGHT
NOTE: There is a left and a right tool rest. When in actual use, the tool rests
TOOL REST
TOOL REST
should be adjusted to within 1/8" of the grinding wheel or other accessory
being used.
Installing Spark Guards and Eye Shield Brackets
RIGHT EYE SHIELD
TURN OFF TOOL AND DISCONNECT FROM POWER SUPPLY.
BRACKET
The combination spark guard and eye shield brackets are assembled and in a
plastic bag. They are identified L for left and R for right. Refer to Figure 2 to Figure 2
install them to the bench grinder using the two screws in the wheel guard (in
some cases these screws will be in the plastic bag). Adjust the edge of the
spark guard to within 1/16" of the grinding wheel or other accessory as RIGHT SPARK
GUARD
shown in the Figure. Tighten the two screws securely.
BOLT WASHER
3