Entryguard Security Lock - Friedrich Kuhl SQ05 Installation And Operation Manual

STEP 2. Route the cord along bottom inside of the unit (See Figures
23 and 24), under the lower left mounting screw embossments
and exit the cord through right side cord opening (See Figure
25) of the decorative front cover. Decorative front cover will
keep cord in place.
Figure 23
FACTORY SETTING WITH LEFT-SIDE
CORD PLACEMENT
Figure 24
NEW CORD ALIGNMENT FOR ROUTING CORD
EXIT TO THE RIGHT OF UNIT
STEP 3.
Figure 25
CLOSE-UP OF
CORD UNDER
LEFT MOUNTING
SCREW
EMBOSSMENT
FRR201

EntryGuard Security Lock

For additional safety, your unit is equipped with EntryGard™ protection,
a feature that helps prevents kick-in intrusions. To engage this feature,
use 2 supplied 1/2" screw (E in parts list) to secure decorative front
cover to sleeve. (See Figure 26 for screw hole locations) .
Figure 26
FRR202
Reinstall the 4 screws removed earlier to secure decorative
front cover with cord exiting to the front bottom of the unit. (4
screws RETAINED FROM STEP 1) and re-connect the power
cable harness (disconnected in STEP 1).
FRR099
21