Table of Contents
Advertisement
◄ The battery temperature is higher than the set maximum tem-
perature.
◄ The charger is overheated! Wait until it cools again! If the
error message is displayed permanently, please contact the
service.
◄ No balancer connected.
◄ The balancer has stated (cell number in parentheses) too high
cell voltage.
◄ The balancer has stated (cell number in parentheses) too low
cell voltage.
◄ The current of the connected motor is too high. Please check
your parameters.
50
◄ The motor was stopped because the other output is in use.
Please check your parameters.
◄ Errors in calibration or in the circuits of the device. If the error
message appears repeatedly, please contact the service.
◄ The cell count in the menu charge / discharge and Sync Mode
menu does not match with the detected number of cells on
Channel 1 and Channel 2.
Troubleshooting
Problem
When connecting the
• Check that the external power supply meets the requirements of the
charger the display
charger and that all cables are properly connected. If the problem per-
remains dark
sists, contact the Service.
The charger does not
• Check whether the battery is properly connected to the charge port
recognize the battery
and the balancer.
• Check whether a cell of the battery is defective.
The battery voltage is
• Check whether the charge settings are correct.
too low after charge
• Check the set delta peak value of NiCd / NiMH batteries.
• Check the connecting cable of the battery.
Discharge mode is not
• Check if the selected cell voltage matches the battery features.
retrieved
• Check whether a cell of the battery is defective.
Battery is not fully
• Charge the battery pack. Run a full cycle charge process by improving
charged after the maxi-
the capacity (battery has been stored for too long or is consumed).
mum charging time
• Check whether in the charge cycle, the minimum discharge voltage
correctly is set.
INNOVATION & TECHNOLOGIE
Possible causes
51
Advertisement
Table of Contents
