Power On And Off - Sharp AL-1651CS Operation Manual

POWER ON AND OFF

The power switch is located on the left side of the machine.
Warning
Power on
Turn the power switch to the "ON" position.
You can select copy settings and press the [START] key (
Copying will start after warm-up.
Caution
The first time the power is turned on after shipment from the factory, a message will
appear in the display asking you to select the language. Select the language with the
[ ] key (
Initial settings
The machine reverts to the initial settings when it is first turned on, when the [CLEAR
ALL] key (
CLEAR" time following the end of a copy job. When the machine reverts to the initial
settings, all settings and functions selected to that point are canceled. The "AUTO
CLEAR" can be changed in the user programs. (p.64)
When in the copy mode
Copy ratio: 100%, Exposure: Automatic
Copy quantity: 0, All special copier modes: Off
16
If you use the machine in a country other than the country
where the machine was purchased, you will need to make sure
that your local power supply is compatible with your model. If
you plug the machine into an incompatible power supply,
irreparable damage to the machine will result.
Only insert the power cord into a properly grounded wall socket.
Do not use extension cords or power strips.
) or [ ] key ( ) and then press the [ENTER] key.
) is pressed, or when no keys are pressed for the preset "AUTO
AL-1651CS
The main screen of copy mode appears.
The ready indicator will light up and other
indicators which show the initial settings of the
display will also light up to indicate the ready
condition. For the initial settings, see the
"Initial settings" (below).
READY TO COPY
100% 8.5x11 0
) during warm-up.