L.E.D. Functionality – Ethernet LED (i2 product shown)
LAN Speed State
10Mbps
100Mbps
1Gbps
Activity State
No Link
Linked
Data Activity
Using the Input/output Panel (i2 product shown)
To access the input/output (I/O) ports, remove the cable cover at the bottom of the unit. Two
security screws need to be removed before accessing the I/O ports.
Note: As a safety precaution, always leave the cable cover door attached when the system is
powered on.
Setting Up the Operating System
If configured with an operating system, the initial setup of the operating system takes
approximately 5-10 minutes. Additional time may be needed depending on touchcomputer
hardware configurations and connected devices.
To set up the Microsoft
LAN LED Status
Orange Color
Green Color
ACT LED Status
Solid (Green Color)
Blinking (Green Color)
®
®
Windows
Operating System for the touchcomputer, turn on the
No Color
No Color
User Manual: Windows I-Series Interactive Signage
UM600086 Rev A, Page 16 of 45