Airflow Direction; Horizontal Sweep; Fan Speed Selection - Carrier 40 series Owner's Manual

Air flow direction
7
The air flow direction can be adjusted to optimize air distribution in the
room.
Press button [7] repeatedly to choose one of the following
1
louvre positions.
Automatic [L1 flashing] - Air direction will be set automatically.
Louvre will be set to the preset position according to the
1a
operation mode.
Fixed [L2 fixed]- 6 positions can be chosen.
1b
The louvre can be set to one of 6 different air flow directions.
Continuous [L3 swinging] - Will continuously swing up and
down.
1c
"Swing" always assures optimal even air distribution in the
room.

Horizontal sweep

8
Press button to start the continuous left and right horizontal
1
swing .
Press button to stop the horizontal swing. The vertical flap will
2
stop at the current position.
Horizontal sweep can be combined with air flow direction [7].
Note

Fan speed selection

5
The air flow intensity can be adjusted to optimize air distribution in the
room.
[M1] Low speed (for night operation)
1a
[M2] Medium speed
1b
[M3] High speed (at start-up, to reach temperature)
1c
[M4] Automatic (fan speed will automatically switch to the
1d
value required for optimum comfort)
Personalisation (myComfort)
6 2 3 4
Memorise the desired operating parameters of the unit, with the
possibility to recall them any time.
The unit can be either off or in operation.
After 10 seconds without pressing any button, the procedure will stop
and the remote control disply resume its original state.
4
M1
5 7 13
L1 L2 L3
L4
M2 M3
N
M4