General Info - Carrier 40 series Owner's Manual

General info

This manual contains information on how to use the air conditioner with
the infrared remote controller.
Please refer to the Installation Operation and maintenance manual of
the indoor unit for routine maintenance and for additional operating info.
The maximum operating range for the remote control is approx. 5 m.
No obstructions such as curtains or plants should be between control
and unit.
Direct sun on the unit receiver may interfere with good signal reception.
The control must be directed toward the unit receiver when pressing the
buttons of the desired functions. An acoustical acknowledgement sound
(beep) will indicate that signal has been received.
The symbol [G] in the display, indicates that the batteries are exhausted
and need to be replaced.
How to change batteries
The remote control operates with two 1.5 V non re-chargeable alkaline
batteries (1.5 V, LR03x2).
Do not use used batteries or batteries of different types, as this may
cause the unit to malfunction.
The average battery life during normal use is approximately one year.
1 ) Open the cover of the battery compartment at the back of the
remote control by pushing the tab in the direction of the arrow (see
picture C).
2 ) Remove the used batteries and insert new batteries.
3 ) Place the battery cover and push it to close.
4 ) Reset the remote control by pressing the reset button [15] with a
sharp object (see picture B).
Note: If the air conditioner does not respond to the remote control,
repeat the battery change operation and press the reset button [15]
again after 5 seconds.
Start / Stop
1
When the air conditioner is not in operation, the remote control
readout will display the time of day only (in case other symbols are lit,
turn control off by pressing button [1]).
Press button [1] to start the air conditioner.
All selected and memorized functions will light up and
1
appear; the unit will operate according to the functions
selected.
Press button [1] to stop the air conditioner.
All indicators on the unit will go out, and the control will
2
display only the current time.
The unit will only emit a "beep", when the signals are
received correctly.
If the unit does not stop, turn the control on (by pressing
button [1]) and repeat the operation.
Note
If button [1] (air conditioner starting) is pressed too soon after
a stop, the compressor will not start for 3/5 minutes due to
the inherent protection against frequent compressor cycling.
2