Actuator Adjustment (Seat Screen); Ilevel® Feature (Optional) - Quantum q-logic 2 Operation Instructions Manual

12

Actuator Adjustment (Seat Screen)

The Q-Logic 2 Controller can control five power seat actuators using the mode select lever and the
joystick.
To select and adjust an actuator:
1. Push the On/Off and Mode Select Lever up once to power on the chair and the controller.
2. Push the On/Off and Mode Select Lever up several times until the seat screen is displayed on the LCD or
push the key 2 select button once to go directly to actuator mode.
3. Push the joystick to the left or right to cycle through the available actuators until the desired actuators are
illuminated on the actuator indicator. See figure 1.
4. When the desired actuator is selected, give a forward command to the joystick to adjust position in one
direction or give a reverse command to the joystick to adjust position in the opposite direction.
5. Push up and release the On/Off and Mode Select Lever until you return to the desired drive profile.
Mode (both)
Figure 1. Actuator Selection
NOTE: The Drive/Function Inhibit status is affected only in the actuator adjustment (seat screen).
iLevel® Feature (Optional)
Your power chair may be equipped with the iLevel® feature that will be used in conjunction with your
TRU-Balance® 3 Power Positioning System. The iLevel® feature is mounted on a Quantum power base
for enhanced stability when the seating system is elevated.
Tilt Mode Elevating Seat Mode
ALR/ELR ALR/ELR
Mode (right)
Recline Mode Recline & ELR/ALR
Mode (both)
ALR/ELR
Mode (left)