Warming Up Engine; Electric Start Models - Yamaha F100D Owner's Manual

Operation
3. Turn the main switch to "
NOTE:
Dual engine users: When the main switch is
turned on, the buzzer operates for a few sec-
onds then stops automatically. The buzzer
also operates if one of the engines stalls.
4. Turn the main switch to "
and hold it for a maximum of 5 seconds.
OFF
34
" (on).
" (start),
ON
START
ZMU01881
5. Immediately after the engine starts, re-
lease the main switch to return it to "
(on).
ECM00191
CAUTION:
Never turn the main switch to "
G
(start) while the engine is running.
Do not keep the starter motor turning for
G
more than 5 seconds. If the starter motor
is turned continuously for more than 5
seconds, the battery will be quickly dis-
charged, thus making it impossible to
start the engine. The starter can also be
damaged. If the engine will not start after
5 seconds of cranking, return the main
switch to " " (on), wait 10 seconds,
then crank the engine again.
EMU27670

Warming up engine

EMU30031

Electric start models

1. After starting the engine, allow it to idle for
3 minutes to warm up. Failure to do so will
shorten engine life.
2. Be sure the low oil pressure warning indi-
cator remains off after starting the en-
gine.
3. Check for a steady flow of water from the
cooling water pilot hole.
ECM01341
CAUTION:
If the low oil pressure warning indicator
G
blinks after the engine starts, stop the
engine. Otherwise serious engine dam-
age could occur. Check the oil level and
add oil if necessary. Consult your
Yamaha dealer if the cause for the low
oil pressure warning indicator cannot be
found.
A continuous flow of water from the pilot
G
hole shows that the water pump is
pumping water through the cooling pas-
"
"