Cleaning And Lubricating The Drive; Chain - Yamaha CRYPTON T110C Owner's Manual

2
1
1. Alignment marks
2. Drive chain slack adjusting nut
3. Drive chain puller
5. Tighten both locknuts, and then
tighten the axle nut and brake
torque rod nut to their specified
torques.
Tightening torques:
Locknut:
7 Nm (0.7 m·kgf, 5.1 ft·lbf)
Axle nut:
60 Nm (6.0 m·kgf, 43 ft·lbf)
Brake torque rod nut:
19 Nm (1.9 m·kgf, 14 ft·lbf)
PERIODIC MAINTENANCE AND ADJUSTMENT
TIP
When tightening the axle nut, hold the
wheel axle with a wrench to keep it from
turning.
(a)
6. Adjust the brake pedal free play.
(See page 6-17.) WARNING! Af-
(b)
ter adjusting the brake pedal
free play, check the operation of
3
the brake light.
7. Make sure that the drive chain pull-
ers are in the same position, the
drive chain slack is correct, and
the drive chain moves smoothly.
Cleaning and lubricating the
drive chain
The drive chain must be cleaned and
lubricated at the intervals specified in
the periodic maintenance and lubrica-
tion chart, otherwise it will quickly wear
out, especially when riding in dusty or
wet areas. Service the drive chain as
follows.
[EWA16080]
NOTICE
The drive chain must be lubricated
after washing the motorcycle, riding
in the rain or riding in wet areas.
1. Remove all dirt and mud from the
TIP
For a thorough cleaning, have a
Yamaha dealer remove the drive chain
and soak it in solvent.
2. Spray Yamaha Chain and Cable
6-22
drive chain with a brush or cloth.
Lube or a high-quality spray-type
drive chain lubricant on the entire
chain, making sure that all side
plates and rollers have been suffi-
ciently oiled.
EAU23016
ECA10583
6