Navigating Menu Screen; Viewing Modes; Auto Sequence Viewing Mode - Lorex LW2750 Series User Manual

8 Using the System

8.2 Navigating Menu Screen

Use the system menus to configure settings.
• Press to open the Main Menu.
• Use the joystick to move the cursor left, right, up, and down.
• Push the joystick to open sub-menus and confirm / save menu selections.
• Press to exit menus without saving changes.

8.3 Viewing Modes

There are four different viewing modes available on the system: single channel viewing,
Auto Sequence Viewing mode (view individual channels automatically in sequence), Quad
mode, and Scan mode (for details, see 12 Scan Mode, page 33).
To change viewing modes:
• Press to select between Quad mode (half-Quad mode when only 2 cameras are
connected) and Auto Sequence viewing mode.
OR
• Press to switch between channels 1~4 in single channel view.
Note
Depending on the number of cameras packaged with the system, half-Quad mode (2 cameras) or single
channel viewing (1 camera) is enabled when you first power on the system.

8.3.1 Auto Sequence Viewing Mode

Auto Sequence Viewing mode cycles through connected channels in full-screen.
#LX400011; r. 1.0/11916/13451; en-US
15