Adjusting The Volume - JVC RX-8030VBK Instructions For Use Manual

Speaker and signal indicators on the display
By checking the following indicators, you can easily confirm which
speakers you are activating and which signals are coming into this
receiver.
Speaker indicators
L C R
SUBWFR
LS RS
SB
What speaker indicators light depends on the speaker setting
(for details, see "Setting the Speakers" on page 27).
• The frames of "L," "C," "R," "LS," "RS, " and "SB" light up,
when the corresponding speakers are set to "LARGE" or
"SMALL" and when the speaker is required for the Surround/DSP
mode currently selected.
• When "SUB WOOFER" is set to "YES,"
page 27).
• All three frames on the row of "SB" are not used at the same time.
When "SBACK OUT" is set to "2SPK," the left and the right ones
are used. When it is set to "1SPK," the middle one is used (see
page 27).
The signal indicators light up to show the incoming signals.
L:
• When digital input is selected: Lights up when the left
channel signal comes in.
• When analog input is selected: Always lights up.
R: • When digital input is selected: Lights up when the right
channel signal comes in.
• When analog input is selected: Always lights up.
C: Lights up when the center channel signal comes in.
LFE: Lights up when the LFE channel signal comes in.
LS: Lights up when the left surround channel signal comes in.
RS: Lights up when the right surround channel signal comes in.
S: Lights up when the monaural surround channel signal
comes in.
SB: Lights up when the surround back channel signal comes in.
Note:
When "DVD MULTI" is selected as the source, "L," "C," "R," "LFE," "LS,"
and "RS" light up.
How to understand the speaker and signal indicator
illumination
L C R
Ex. No sound comes out of the
SUBWFR LFE
LS RS
SB
18
Signal indicators
L C R
LFE
LS S RS
SB
lights up (see
SUBWFR
center speaker and surround
back speakers though center
channel and surround back
channel signals are coming
into this receiver.
Selecting different sources for picture and
sound
While watching pictures from a video source, you can listen to
sound of an audio source.
• Once you have selected a video source, pictures of the selected
source are sent to the TV until you select another video source.
Press one of the audio source selection buttons while viewing the
picture from a video component such as the VCR or DVD
player, etc.
For RX-8030VBK
PHONO CD CDR TAPE/MD FM
On the unit
For RX-7030VBK
CD TAPE/CDR FM
On the unit
Note:
When you see the picture through the COMPONENT VIDEO jacks,
you cannot use this function.

Adjusting the Volume

On the front panel:
To increase the volume, turn MASTER VOLUME clockwise.
To decrease the volume, turn it counterclockwise.
From the remote control:
To increase the volume, press VOLUME +.
To decrease the volume, press VOLUME –.
CAUTION:
Always set the volume to the minimum before starting any sources. If
the volume is set at its high level, the sudden blast of sound energy
can permanently damage your hearing and/or ruin your speakers.
Notes:
• The volume level can be adjusted within the range of "0" (minimum)
to "70" (maximum).
• If you set One Touch Operation to "ON" (see page 30), you do not
have to adjust the volume level each time you change the source. It
is automatically set to the stored level.
CD FM/AM
CDR TAPE/MD
PHONO
AM
On the remote
CD FM/AM
AM
TAPE/CDR
On the remote