Installing And Charging Battery - Epson TM P60II User Manual

English

Installing and Charging Battery

Follow the steps below to install and charge the battery.
Note:
The battery can be charged only when the temperature is 0 ~ 40°C {32 ~ 104°F}.
1. Make sure that the printer is turned off.
2. Slide the battery cover (C 18) to open it.
3. Install the battery (C 19), and close the battery cover.
4. Connect the AC adapter to the printer. See illustration A 3 for the Charging
Connector. Charging starts.
Note:
Charging will take approximately 2.5 hours with the AC adapter or with the optional
battery charger OT-CH60II. For detailed information on the battery charger, see its user's
manual. The time described above is the time required to charge a battery pack that is fully
discharged.
Charging the battery at 35
the printer, which may reqire a longer charging time than the specified one. The Charge
LED flashes while charging the battery.
Switching Issuing Mode
You can switch the issuing mode between the label continuous issuing mode and
the label peeler issuing mode by folding the peeler holder under the peeler cover.
Installing or Replacing Roll Paper
Follow the steps below to install or replace the roll paper.
CAUTION:
Be sure to use roll paper that meets the specifications.
Note:
Do not use the roll paper that have the paper glued to the core.
When Using the Label Continuous Issuing Mode
Press the open button (A 8) to open the roll paper cover (A 9) and the peeler
1.
cover (A 2).
2. Remove the used roll paper core if there is one.
3. Fold the peeler holder (A 7) under the peeler cover (A 2). This covers the label
peeler sensor (A 1). See illustration D.
When installing the label paper horizontally
4. Set a new roll of paper inside the roll paper holder, and pull the leading edge
of the roll paper. See illustration E.
Note:
Note the direction the paper comes off the roll.
5. Close the roll paper cover. See illustration F.
6. Close the peeler cover. See illustration G.
When installing the label paper vertically
Set a new roll of paper inside the roll paper cover. See ① in illustration H.
4.
Note:
Be sure that the roll paper side is at the bottom when you install the printer vertically.
14 TM-P60II with Peeler User's Manual
C {95°F} or higher activates the internal temperature control of
°