Epson TM P60II User Manual page 15

Pull the leading edge of the roll paper. See ② in illustration H.
5.
Align the left edge of the roll paper with the edge of the cover. See ③ in
6.
illustration H.
Note:
Note the direction the paper comes off the roll.
7. Close the roll paper cover and the peeler cover.
When Using the Label Peeler Issuing Mode
1. Press the open button (A 8) to open the roll paper cover (A 9) and the peeler
cover (A 2).
2. Remove the used roll paper core if there is one.
3. Press the peeler switch lever (A 6) to lift the peeler holder (A 7). See
illustration I.
When installing the label paper horizontally
4. Set a new roll of paper inside the roll paper holder. Remove the first label off,
and pull the label paper so you can set the backing paper in the peeler holder
(A 7). See illustration J.
Note:
Note the direction the paper comes off the roll.
5. Close the roll paper cover. See illustration K.
6. Close the peeler cover. See illustration L.
When installing the label paper vertically
Set a new roll of paper inside the roll paper cover. See ① in illustration H.
4.
Note:
Be sure that the roll paper side is at the bottom when you install the printer vertically.
Pull the leading edge of the roll paper. See ② in illustration H.
5.
Align the left edge of the roll paper with the edge of the cover. See ③ in
6.
illustration H.
Note:
Note the direction the paper comes off the roll.
7. Close the roll paper cover and the peeler cover.
Note:
Removing the issued label enables the label peeler detector to detect a paper end and the
printer to issue the next label.
If the first label is not removed when using the label peeler issuing mode, the thickness of
the label and the backing paper overloads the peeler holder, possibly stopping the paper feed
motor.
When closing the peeler cover, make sure to close it firmly, pressing both ends.
See illustration M.
You can cut the label paper
When the label is completely fed to the peeling position, the printer goes in the label
removal waiting state, so remove the label.
When the label peeler detector detects the paper at the power on, the printer goes in the
label removal waiting state and the Error LED comes on. Be sure to remove the label before
powering off the printer. Otherwise, the printer goes into the label removal waiting state
when it is powered on again.
TM-P60II with Peeler User's Manual 15
English