Table of Contents
Advertisement
2. Pull the rear end of the shelf support
away from the side wall and remove
it.
2
1
Install the shelf supports in the opposite
sequence.
The retaining pins on the
telescopic runners must
point to the front.
11.4 Catalytic cleaning
CAUTION!
Do not clean the catalytic
surface with oven sprays,
abrasive cleaning agents,
soap or other cleaning
agents. This will damage the
catalytic surface.
Spots or discolouration of
the catalytic surface have no
effect on catalytic
properties.
WARNING!
Keep children away when
you clean the oven at a high
temperature. The oven
surface becomes very hot
and there is a risk of burns.
CAUTION!
Always turn the oven light on
while using the catalytic
cleaning (if applicable).
Before activating the
catalytic cleaning remove all
the accessories from the
oven.
The walls with a catalytic coating are self-
cleaning. They absorb fat which collects
on the walls while the appliance
operates.
To support the self-cleaning procedure,
heat the empty oven on a regular basis.
1. Clean the oven floor with warm water
and washing up liquid, then dry it.
2. Set the oven temperature to 250 °C
and let the oven operate for 1 hour.
3. When the appliance is cool, clean it
with a soft and moist sponge.
11.5 Removing and installing
the door
You can remove the door and the
internal glass panels to clean it. The
number of glass panels is different for
different models.
WARNING!
Be careful when you remove
the door from the appliance.
The door is heavy.
1. Open the door fully.
2. Fully lift up the clamping levers (A) on
the two door hinges.
A
3. Close the door until it is at an angle
of approximately 45°.
45°
4. Hold the door with one hand on each
side and pull it away from the
appliance at an upwards angle.
5. Put the door with the outer side
down on a soft cloth on a stable
surface. This is to prevent scratches.
ENGLISH
23
A
Advertisement
Table of Contents
