Garmin GTX330 Installation Manual page 56

5.2.12 Temperature Page
SENSOR INSTALLED
Sets the Sensor to YES or NO. Default is NO.
UNITS
Sets the units to degrees Fahrenheit or Centigrade. Default is degrees C.
5.2.13 Mode S Address Entry Pages
It is VERY important to enter the Mode S address correctly in the GTX 330.
When the unit is turned on for the first time, or an invalid address is recognized, the unit prompts the user
to enter a valid aircraft address.
Once the aircraft address is entered, the unit remains on in the same mode as before.
5.2.13.1 US TAIL and Hex ADDRESS Entry Pages
For first time turn-on, proceed to step 5. Otherwise begin at step 1, with the unit turned off:
1. To enter the configuration pages, press and hold the FUNC key while powering on the unit.
2. Power the unit on by pressing the ON, ALT, or STBY key or turn on with the avionics master
switch (while holding the FUNC key). The unit performs a self-test routine and displays a "Jump
to Diagnostics" page.
3. Navigate to the address entry page by repeatedly pressing
the FUNC Key.
a. The page that appears is either ADDRESS US TAIL# N _
_ _ _ _ .
b. Or ADDRESS HEX _ _ _ _ _ _ .
It is not necessary for the installer to convert a US aircraft registration
number (N-number) to a Hex address.
registration number to hexadecimal automatically.
4. To select between Hex or Tail number, press the CRSR key, then 8 or 9 key to move to the
correct selection.
5. For entering either the address hex code or the US registration number, press the CRSR key 1
time. (This highlights the address field).
6. Enter the aircraft address using the number keys. Press a key repeatedly to scroll through the
digit/alpha characters for that key.
Page 5-16
Revision R
NOTE
NOTE
The GTX 330 converts the US
GTX 330/GTX 330D Installation Manual
TEMPERATURE Page
MODE S US TAIL # Page
MODE S Address HEX Page
190-00207-02