Advertisement
4 Add ice or frozen ingredients to the goblet.
This includes frozen fruit, frozen yoghurt, ice cream or ice.
5 Fit the lid and turn until the interlock tab locks into the
handle
. Your blender will not work if the lid
is unlocked.
6 Either put the cap into the lid, or place the stirrer in the hole.
The stirrer can be used when blending thick mixtures
or when large quantities of frozen items are used.
7 Select speed 1 and allow the ingredients to blend until
mixed completely.
Use speed 2 to mix and smooth the drink just before
serving.
Use the stirrer by moving it in an anti clockwise
direction.
8 Place a glass underneath the tap and pull the tap lever
down to dispense the drink
To help dispense the last amount of a thick smoothie
drink, add a few tablespoons of liquid to increase the
flow.
hints
To make a thinner smoothie drink add more liquid.
To make a thicker smoothie drink add more frozen
ingredients.
Before fitting the lid, push the solid ingredients into the
liquid using the stirrer.
Use the PULSE to operate the power unit in a start
stop action to control the texture of your drink. Take
care as this automatically selects the higher speed and
may cause the drink to be thrown up the sides and
onto the lid of the goblet.
After blending, some drinks may not be completely
smooth due to seeds or the fibrous nature of
ingredients.
Some drinks may separate on standing, therefore it's
best to drink them straight away. Separated drinks
should be stirred before drinking.
important
Never blend dry ingredients (eg spices, nuts) or run the
Smoothie Blender empty.
Don't use the blender as a storage container. Keep it
empty before and after use.
Some liquids increase in volume and froth during
blending eg milk, so do not overfill and ensure the lid is
correctly fitted.
To ensure long life of your Smoothie Blender, never run
it continuously for longer than 60 seconds.
Never blend food that has formed a solid mass during
freezing, break it up before adding to the goblet.
.
cleaning
Always switch off, unplug and dismantle before
cleaning.
Never let the power unit, cord or plug get wet.
Don't wash any part in the dishwasher.
Some foods, eg carrot, will discolour the plastic.
Rubbing with a cloth dipped in vegetable oil helps
remove discolouring.
power unit
Wipe with a damp cloth, then dry.
juicers
filter
If the filter is too tight to remove, wait a few minutes
until it loosens up.
Clean using a soft brush.
Check the filter regularly for signs of damage.
Do not use if the filter is damaged. Refer to
"service and customer care"
other parts
Wash, then dry.
blender
Always wash immediately after use. Don't let food dry
onto the goblet assembly as this will make cleaning
difficult.
Regularly dismantle the tap and clean thoroughly.
blender unit
Before dismantling the blender, half fill the goblet with
warm water. Fit the lid and cap then place on the
power unit. Switch to 2 and whilst running, open the
tap and allow the water to drain into a container to
clean the valve. This can be repeated until the water
runs clear.
Do not immerse the blender base unit in water.
cleaning the tap
Remove the tap assembly from the goblet, then soak
the tap in hot soapy water with the valve open
Wash thoroughly then rinse and dry.
lid, cap, stirrer
Wash by hand, rinse with clean water then dry.
4
.
Advertisement
