Table of Contents
Advertisement
f. Adjusting the nozzle wipe
The nozzle wipe should sit slightly higher than the height of the nozzle tip, so that when the nozzle is moved over the wipe, the wipe brushes over
the nozzle tip.
Use 'Manual move' to position the nozzle over the nozzle wipe box.
To adjust the height of the nozzle wipe, remove the nozzle wipe box and loosen the M3 nuts and bolts on the back of the wipeusing the
2.5mm hex driver supplied in the toolkit. Use the reference holes togauge the adjustment, and ensure that the nozzle wipe is horizontal.
Retighten the M3 nuts, replace the nozzle wipe box and re-check nozzle wipe position.
3D Touch
Page 60
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the 3D Touch and is the answer not in the manual?