Clearing The Print Bed - Bfb 3D Touch Set Up And Operation Manual

a. Clearing the print bed
It is essential to clean the print bed before printing. This makes sure that the first printed layer makes a good contact with the bed.
Ensure the bed transport stopper has been removed
For transit, a white stopper is fitted to the front bed keyhole. This prevents the bed from coming off the bed arms during transport. Remove this
stopper and retain for future transport.
Do not print attempt to print with the white stopper in place. Remove the white bed stopper before printing.
Remove existing prints from the print bed
We do test prints on each 3D Touch as part of our quality control. We leave these on the print bed to show that the printer has been checked, and to
demonstrate some basic prints.
Remove any previous prints with the model removal tool. Slide the edge between the bed and the first layer to remove the entire print.
3D Touch
Page 18