Load The Extruders - Bfb 3D Touch Set Up And Operation Manual

h. Load the extruders
Before loading a reel, the end of the filament must be prepared to prevent damage to the delivery tubes. This procedure is
damage to the delivery tubes, which may in turn block a nozzle.
Cut the end of the filament at 45° from both sides to produce a point.
Remove all sharp edges. The tip should feel smooth.
Reel positions for each extruder are indicated below.
Note: delivery tubes for each extruder run from
3D Touch
right to left as indicated below:
Page 31
essential to prevent any