Select A Tape-/Disc Device For Direct Operation - Silvercrest SFB10 Operating Instructions Manual

1. Hold the S button r down for a little longer than
3 seconds. The notice „LANGUAGE SETUP" appears.
2. With the  or  button t select "SYSTEM SETUP" and
confirm with the OK button l.
3. With the  or  button t select "VOL/MUTE SETUP"
and confirm with the OK button l.
4. The LCD display q shows "ALL VOL SET". Press the OK
button l, the display changes to „ALL VOL MODE".
5. Now press the device button e for the device that is to be
controlled by the global volume control.
6. If the specified device is equipped with a volume control,
"SUCCESS" will be displayed briefly and the menu will
close. From now on the volume control functions on the
device just specified.
7. If this device is not equipped with its own volume control
the URC will not allow this selection and shows "VOLUME
ERROR". Even then the menu will close. The volume con-
trol will then continue to function on the former device.
You can also deactivate the global volume control for specific
devices.
1. Forthisselectinthemenu"VOL/MUTESETUP"withthe
orbuttontthefunction"MODEVOLSET"and
confirmwiththeOKbuttonl.IntheLCDdisplayqap-
pears„MODEVOLMODE".
2. Now press the device button e for the device that is to
be excluded from the global volume control. The LCD
display q shows „SUCCESS" and the global volume
control is deactivated if the URC is working in the opera-
tional mode of one of the selected devices.
Youcanagainoverridethesettingsinthe"VOL/MUTE
SETUP"menu.
1. Forthisselectinthemenu"VOL/MUTECONF"withthe
orbuttontthefunction"VOL/MUTERESET"and
confirmwiththeOKbuttonl.
2. The LCD display q prompts you, with CONFIRM RESET,
to a confirmation which is done by pressing the OK
button l. PresstheOKbuttonlifyouwanttodelete
thesetting,thedisplayed"SUCCESS"thenconfirmsthe
deletionofthedeviceassignmenttoglobalvolumecon-
trol. Otherwise you press the EXIT button y to abort the
deletion.

Select a Tape-/Disc device for direct operation

You can select a tape or disk device that you can control
with the playback buttons f without first having to press the
corresponding device button e.
1. Hold down the S button r for a little longer than 3 sec-
onds. The notice "LANGUAGE SETUP" appears.
2. With the  or  button t select "SYSTEM SETUP" and
confirm it with the OK button l.
- 16 -