Timer Configuration; Sleep Timer; Event Timer - Silvercrest SFB10 Operating Instructions Manual

press the device button e whose assignment you want to
delete. To conclude, "SUCCESS" briefly appears, then you
will again read "MODE" in the LCD display. Now press
any other further desired device buttons e to also delete
their assignment.
7. Otherwise, you can exit the menu by pressing the EXIT
button y.

Timer configuration

The URC offers 2 timer modes, sleep timer and event timer.

Sleep timer

1. Press the device button e for the device that is to be con-
trolled (i.e. VCR).
2. Hold down the S button r for a little longer than 3 sec-
onds. The notice "LANGUAGE SETUP" appears.
3. Press the  or  button t until "TIMER SETUP" is
shown. Press the OK button l "TIMER SLEEP" appears in
the LCD display q. Confirm the selection of this function
with the OK button l.
4. Now, below to the right in the LCD display q blinks the
minutes for the remaining time of the selected device.
Set with the  or  button t the desired value from 1
to 99 minutes. Press the OK button l to confirm. With
programmed sleep-timer the LCD display q shows "
on the right next to the time.
5. Position the remote control in such a way that your infra-
red signal can reach the device to be switched off. After
expiration of the set time the remote control will switch the
device off.
6. If you now press the S button r "SL" is shown in the dis-
play q below on the left.

Event timer

The remote control has 4 event timers available via which
you are allowed to send out specific series of button combi-
nations at designated times.
1. Hold down the S button r for a little longer than 3 sec-
onds. The notice "LANGUAGE SETUP" appears.
2. With the  or  button t select "TIMER SETUP" and
confirm with the OK button l. "TIMER SLEEP" appears
in the LCD display q. With the  or  button t select
the desired memory slot "TIMER SETUP 1" to "TIMER
SETUP 4" and confirm with the OK button l.
3. Now the hour of the time of day, to which the desired
button combinations are to be carried out, blinks. Set with
the  or  button t the desired hour and press for con-
firmation the OK button l.
4. Now the minutes of the time of day, to which the desired
button combinations are to be carried out, blinks. Set with
the  or  button t the desired minutes and press for
confirmation the OK button l.
- 18 -
z "
z