Throttle Lever - Yamaha YFM250R-W Owner's Manual

ECB00050
NOTICE
See the starting instructions on page 6-1 prior
to starting the engine.
EBU28061
Light switch "
Set the switch to "
4
Set this switch to "
Set the switch to " " to turn off the headlight.
ECB00030
NOTICE
Do not use the headlight with the engine turned
off for an extended period of time, otherwise
the battery may discharge to the point that the
starter motor will not operate properly. If this
should happen, remove the battery and re-
charge it.
EBU27990
Turn signal switch "
To signal a right-hand turn, push this switch
to " ". To signal a left-hand turn, push this switch
to " ". When released, the switch returns to the
center position. To cancel the turn signal lights,
push the switch in after it has returned to the center
position.
/ / "
" to turn on the high beam.
" to turn on the low beam.
/ "
EBU18170
Horn switch "
Press the switch to sound the horn.
EBUM0220
Hazard switch "
Turn this switch to "
(simultaneous flashing of all turn signal lights).
The hazard lights are used in case of an emergen-
cy or to warn other drivers when your vehicle is
stopped where it might be a traffic hazard.
ECB00860
NOTICE
Do not use the hazard lights for an extended
length of time with the engine not running, oth-
erwise the battery may discharge.
EBU18280

Throttle lever

Once the engine is running, movement of the throt-
tle lever will increase the engine speed.
Regulate the speed of the ATV by varying the
throttle position. Because the throttle is spring-
loaded, the ATV will decelerate, and the engine will
return to an idle any time the hand is removed from
the throttle lever.
4-4
"
"
" to turn on the hazard lights