Yamaha MT-01 Owner's Manual page 50

Hide thumbs Also See for MT-01:
Table of Contents

Advertisement

PERIODIC MAINTENANCE AND MINOR REPAIR
CAUTION:
Make sure that the oil filler cap is se-
curely tightened, otherwise oil may
seep out when the engine is run-
ning.
To change the engine oil (with or
without oil filter cartridge replace-
ment)
1. Remove the cowling. (See page
6-5.)
2. Start the engine, warm it up for
several minutes, and then turn it
off.
6
3. Place an oil pan under the oil tank
to collect the used oil.
4. Remove the engine oil filler cap
and drain bolt to drain the oil from
the oil tank.
ECA10900
1. Engine oil drain bolt (oil tank)
5. Place an oil pan under the engine
to collect the used oil.
6. Remove the engine oil drain bolt to
drain the oil from the crankcase.
1. Engine oil drain bolt (crankcase)
NOTE:
Skip steps 7–11 if the oil filter cartridge
is not being replaced.
7. Remove the rectifier/regulator by
1. Rectifier/regulator
2. Bolt
8. Remove the oil filter cartridge with
6-8
removing the bolts.
an oil filter wrench.

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents