Operation
Check that no water leaks from the joints be-
tween the exhaust cover, cylinder head, and
body cylinder.
EMU27670
Warming up engine
EMU27715
Manual start and electric start models
1.
After starting the engine, allow it to idle for
3 minutes to warm up. Failure to do so will
shorten engine life.
2.
Be sure the low oil pressure-alert indica-
tor goes off after starting the engine.
NOTICE: If the low oil pressure-alert
indicator blinks after the engine starts,
stop the engine. Otherwise serious
engine damage could occur. Check
the oil level and add oil if necessary.
Consult your Yamaha dealer if the
cause for the low oil pressure-alert in-
dicator cannot be found.
EMU36530
Checks after engine warm-up
EMU36540
Shifting
While tightly moored, and without applying
throttle, confirm that the engine shifts smooth-
ly into forward and reverse, and back to neu-
tral.
EMU36980
Stop switches
Turn the main switch to "
G
engine stop button and make sure the en-
gine stops.
42
G
G
EMU34530
EWM00180
Before shifting, make sure there are no
swimmers or obstacles in the water near
you.
ECM01610
NOTICE
Warm up the engine before shifting into
gear. Until the engine is warm, the idle
speed may be higher than normal. High
idle speed can prevent you from shifting
back to neutral. If this occurs, stop the en-
gine, shift to neutral, then restart the en-
gine and allow it to warm up.
To shift out of neutral
1.
[ECM01830]
1. Neutral interlock trigger
2.
", or press the
Confirm that removing the clip from the en-
gine shut-off switch stops the engine.
Confirm that the engine cannot be started
with the clip removed from the engine shut-
off switch.
Shifting
WARNING
Pull the neutral interlock trigger up (if
equipped).
Move the remote control lever / gear shift
lever firmly and crisply forward (for for-
ward gear) or backward (for reverse
gear) [about 35° (a detent can felt) for re-
mote control models]. Be sure to check