Lubrication; Flushing Power Unit - Yamaha F6A Owner's Manual

Maintenance
10. If the "Fogging Oil" is not available, run
the engine at a fast idle until the fuel sys-
tem becomes empty and the engine
stops.
11. Drain the cooling water completely out of
the motor. Clean the body thoroughly.
12. If the "Fogging Oil" is not available, re-
move the spark plug(s). Pour a teaspoon-
ful of clean engine oil into each cylinder.
Crank several times manually. Replace
the spark plug(s).
13. Drain the fuel from the fuel tank.
TIP:
Store the fuel tank in a dry, well-ventilated
place, not in direct sunlight.
EMU28402

Lubrication

1. Install the spark plug(s) and torque to
proper specification. For information on
spark plug installation, see page 64.
2. Change the gear oil. For instructions, see
page 69. Inspect the oil for the presence
of water that indicates a leaky seal. Seal
replacement should be performed by an
authorized Yamaha dealer prior to use.
3. Grease all grease fittings. For further de-
tails, see page 62.
TIP:
For long-term storage, fogging the engine
with oil is recommended. Contact your
Yamaha dealer for information about fogging
oil and procedures for your engine.
EMU28443

Flushing power unit

Perform this procedure right after operation
for the most thorough flushing.
56
ECM01530
NOTICE
Do not perform this procedure while the
engine is running. The water pump may be
damaged and severe damage from over-
heating can result.
1. After shutting off the engine, unscrew the
garden hose connector from the fitting on
the bottom cowling.
1. Fitting
2. Garden hose connector
3. Garden hose adapter
2. Screw the garden hose adapter onto a
garden hose, which is connected to a
fresh water supply, and then connect it to
the garden hose connector.
3. With the engine off, turn on the water tap
and let the water flush through the cool-
ing passages for about 15 minutes. Turn