Inspecting And Replacing Anode(S); Checking Battery (For Electric Start Models) - Yamaha F6A Owner's Manual

4. Clean the filter (located on the end of the
suction pipe) in a suitable cleaning sol-
vent. Allow the filter to dry.
5. Replace the gasket with a new one. Re-
install the fuel joint assembly and tighten
the screws firmly.
EMU29312

Inspecting and replacing anode(s)

Yamaha outboard motors are protected from
corrosion by sacrificial anodes. Inspect the
external anodes periodically. Remove scales
from the surfaces of the anodes. Consult a
Yamaha dealer for replacement of external
anodes.
ECM00720
NOTICE
Do not paint anodes, as this would render
them ineffective.
TIP:
Inspect ground leads attached to external an-
odes on equipped models. Consult a Yamaha
dealer for inspection and replacement of inter-
nal anodes attached to the power unit.
EMU29322
Checking battery (for electric start
models)
EWM01900
WARNING
Battery electrolytic fluid is poisonous and
caustic, and batteries generate explosive
hydrogen gas. When working near the bat-
tery:
Wear protective eye gear and rubber
G
gloves.
Maintenance
ZMU02067
71