DN
EMU28060
Cruising in shallow water
The outboard motor can be tilted up partially
to allow operation in shallow water.
EMU32850
Power trim and tilt models
The outboard motor can be tilted up partially
to allow operation in shallow water.
EWM00660
WARNING
Place the gear shift in neutral before set-
G
ting up for shallow water cruising.
Return the outboard motor to its normal
G
position as soon as the boat is back in
deeper water.
ECM00260
CAUTION:
Do not tilt the outboard motor up so that
the cooling water inlet on the lower unit is
above the surface of the water when set-
ting up for and cruising in shallow water.
Otherwise severe damage from overheat-
ing can result.
EMU32910
Procedure for power trim and tilt
1.
Place the remote control lever / gear shift
lever in neutral.
ZMU04255
2.
Slightly tilt the outboard motor up to the
desired position using the power trim and
tilt switch.
3.
To return the outboard motor to the nor-
mal running position, press the power
trim and tilt switch and slowly tilt the out-
board motor down.
Operation
49